Bimba STP-10 Bedienungsanleitung PDF herunterladen (Seite 35)

STP-10 Hardware Manual

Mechanical Outline

Mounting the Drive

You can mount your drive on the wide or the narrow side of the chassis using #6 screws. If possible, the drive should be securely

fastened to a smooth, at metal surface that will help conduct heat away from the chassis. If this is not possible, then forced air-

ow from a fan may be required to prevent the drive from overheating.

• Never use your drive in a space where there is no air ow or where other devices cause the surrounding air to be

more than 40°C.

• Never put the drive where it can get wet or where metal or other electrically conductive particles can get on the

circuitry.

• Always provide air ow around the drive. When mouting multiple STP drives near each other, maintain at least one

half inch of space between drives.

3.0

1.775

5.0

6X SLOT 0.16

WIDE, FULL R

0.663

1.98

0.61

4.74

1 2 ... 30 31 32 33 34 35 36 37 38 39

Keine Kommentare

Bimba STP-10 Bedienungsanleitung Seite 35